Radius Ratio Calculator – Predicting Coordination in Ionic Solids
The radius-ratio rule predicts how many anions surround a cation in an ionic crystal from a single number, ρ = r₊ / r₋. A small cation can only touch a few large anions before the anions bump into each other, so small ratios give low coordination numbers and large ratios give high ones. This radius ratio calculator works out ρ from Shannon ionic radii or from radii you type, names the coordination polyhedron and structure type, draws the ions to scale so you can see whether the cation fits, and checks the prediction against the real structure.
Where the limiting ratios come from
Put a cation of radius r at the centre of a polyhedron of anions of radius R, and let θ be the angle at the cation between two neighbouring anions. The anions touch each other and the cation at the same time when the cation–anion distance R + r equals R / sin(θ/2). Rearranging gives the limiting ratio:
ρ_limit = 1 / sin(θ/2) − 1
CN 3 trigonal θ = 120° 2/√3 − 1 = 0.155
CN 4 tetrahedral θ = 109.47° √(3/2) − 1 = 0.225
CN 6 octahedral θ = 90° √2 − 1 = 0.414
CN 8 cubic θ = 70.53° √3 − 1 = 0.732
CN 12 cuboctahedral θ = 60° 1Below its limit the anions touch each other first and the cation rattles in the hole, which is unstable, so the rule picks the highest CN whose limit ρ still reaches. Square-planar CN 4 has the same limit as the octahedron (√2 − 1), but the rule reports the higher CN, 6. The cross-section drawing shows both cases: switch NaCl (ρ = 0.564) to CN 8 and the sodium ion visibly rattles; at CN 6 it touches all six chlorides with the anions 0.21 R apart.
Self-consistent radii
Ionic radii grow with coordination number: Cs⁺ is 1.67 Å with six neighbours and 1.74 Å with eight. Using the CN6 radius once is only a first guess, so the Auto mode repeats the calculation with the radii for the predicted CN until the answer stops changing. For CsCl it goes 0.923 → 8, then 0.961 → 8, and converges. If the next radius is not tabulated (Si⁴⁺ has no CN3 value) it stops and says so, and if the CN flips back and forth it reports the cycle. For formulas other than MX the anion's CN follows from stoichiometry, CN(anion) = CN(cation) × p / q, so CaF₂ is 8 : 4 and TiO₂ 6 : 3.
Which ions fit a given hole?
The hole-fit tab turns the rule around. For an anion of radius R each polyhedron accepts cations between limit_low × R and limit_high × R: for O²⁻ (1.40 Å) the octahedral hole takes 0.580–1.025 Å and the tetrahedral hole 0.315–0.580 Å. Al³⁺ (0.535 Å) lands in the tetrahedral range, yet in corundum it is octahedral.
Why the rule is only a guide
Real ions are not hard, charged spheres. Covalent bonding favours low, directional coordination (AgI and CuCl adopt the zinc blende structure, BeO wurtzite), large anions are polarisable, and the lattice energies of competing structures differ by only a few percent. The alkali-halide tab runs all 20 salts: the rule predicts CN 8 for NaF, KCl and RbCl, for example, yet every alkali halide except CsCl, CsBr and CsI is rock salt at room conditions. The tally is computed from the data, not typed in.
About the data
Radii are Shannon's 1976 effective ionic radii (Acta Cryst. A32, 751–767) for about 40 common ions at each listed coordination number, on the scale r(O²⁻, CN6) = 1.40 Å. Shannon's crystal radii are 0.14 Å larger for cations and 0.14 Å smaller for anions, so mixing the two columns changes every ratio. Where an anion has no radius at the needed CN (Cl⁻, Br⁻, I⁻ and S²⁻ are only listed at CN6) the CN6 value is used and the step table says so. Everything runs in your browser; no data is sent anywhere.